AshJR7202 (72%)
hi, u can use any one of the following: ***********hobbycity****/hobbycity/store/uh_viewItem.asp?idproduct=4365 ***********hobbycity****/hobbycity/store/uh_viewItem.asp?idproduct=8519 But be careful while tightening the screw, it may damage ur CF bar
maukabud
(52%)
Elder- um, most folks, and ARF kits assemble a pushrod assembly by heat shrinking (then CA'ing) a short length of "music wire" to either end of the carbon rod...that way you can make simple "Z-bends" in the wire for your servo horn and control horn.
All hobbyKing.com® content is copyright 1999 - 2010 by hobbyKing.com® and hexTronik Ltd. except where otherwise indicated.
The hobbyKing.com® logo and name are both trademarks of hexTronik Limited.
